9. Remove the LOS.
•
If the unit is flipped on its side, pull out the LOS.
•
If using the H1 LOS service kit, start to wind down the jack and remove the LOS.
When handling the LOS, insert the ESD protection plugs into the connections of the LOS.
10. Replace the LOS.
11. To re-install, follow these steps in reverse order.
12. After re-installing the LOS, perform optical adjustments (on page 14) and software calibration.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
83