3. Disconnect the harness.
4. Remove the CLB bracket and board.
5. To re-install, follow these steps in reverse order.
Replacing the status LED board (SLB)
The status LED board (SLB) provides visual information about the operational state of the projector.
1. Remove the rear cover (on page 33).
2. Disconnect the SLB harness connector J1 from the SLB.
3. Remove the two screws securing the SLB and remove the board.
4. Replace the SLB assembly.
5. To re-install, follow these steps in reverse order.
Replacing the low voltage current source (LVCS)
board
1. Remove the laser driver card cage (on page 58).
2. Loosen the two captive screws securing the bottom cover plate and pivot to remove it.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
70