4. Move the bracket back and make sure it does not come in contact with the light engine.
5. Replace the fan.
6. To re-install, follow these steps in reverse order.
Replacing the red formatter fan (#5)
The red formatter fan provides cooling for the red light engine formatter board.
1. Remove the top cover (on page 33).
2. If the light engine coolant hoses are in the way, disconnect them.
3. Disconnect the fan #5 harness inline connector.
4. To remove the fan with the bracket, loosen the three captive screws.
5. Remove the two screws securing the fan to the bracket.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Ventilation and cooling
46