Table of Contents
Advertisement
3. Disconnect the HVCS harness connectors J161 from the board being replaced.
4. Slide the HVCS board out of the cage and remove it.
5. Replace the HVCS board.
6. To re-install, follow these steps in reverse order.
Replacing the laser backplane (LBP7) board
1. Remove the laser driver card cage (on page 58).
2. Loosen the two captive screws securing the bottom cover plate and pivot to remove it.
4K40-RGB Series Service Guide–D4K40-RGB, Roadie 4K40-RGB, Mirage 4K40-RGB
020-102960-02 Rev. 1 (12-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Printed circuit boards and sensors
72
Hide quick links:
Advertisement
Table of Contents
