Cycle782 - Adjust To Load - Siemens SINUMERIK 840D sl Programming Manual

No. Parameter Parameter
mask internal
12
<_AMODE>
13
<S_FW>
14
<S_HW>
3.25.1.33

CYCLE782 - adjust to load

Note
To use CYCLE782, a license is required for the option "Intelligent load adjustment":
Syntax
CYCLE782(<S_MODE>, <S_TESTAXIS>, <S_VALUE>)
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Data type Meaning
INT Alternative mode
UNITS:
TENS:
REAL Clear angle of the dressing tool
REAL Holder angle of the dressing tool
Work preparation
3.25 Programming cycles externally
Form-truing selection, new/continue
1 = New
2 = Continue
Select form-truing allowance
0 = From the rough contour to the
lowest point of the contour
1 = From the rough contour to the
highest point of the contour
1091