Cycle83 - Deep-Hole Drilling 1 - Siemens SINUMERIK 840D sl Programming Manual

Work preparation
3.25 Programming cycles externally
No. Parameter Parameter
mask internal
13 ZD
<S_ZD>
14 FD
<S_FD>
3.25.1.23 CYCLE83 – deep-hole drilling 1
Syntax
CYCLE83(<RTP>, <RFP>, <SDIS>, <DP>, <DPR>, <FDEP>, <FDPR>, <_DAM>,
<DTB>, <DTS>, <FRF>, <VARI>, <_AXN>, <_MDEP>, <_VRT>, <_DTD>,
<_DIS1>, <_GMODE>, <_DMODE>, <_AMODE>)
Parameter
No. Parameter Parameter
mask internal
1 RP
<RTP>
2 Z0
<RFP>
3 SC
<SDIS>
4 Z1
<DP>
5 Z1
<DPR>
6 D
<FDEP>
7 D
<FDPR>
8 DF
<_DAM>
9 DTB
<DTB>
10 DTS
<DTS>
11 FD1
<FRF>
12
<VARI>
13
<_AXN>
14 V1
<_MDEP>
15 V2
<_VRT>
16 DT
<_DTD>
1068
Data type Meaning
REAL Incremental remaining drilling depth in relation to final drilling depth or
absolute (see <_AMODE> TEN THOUSANDS)
REAL Remaining drilling feedrate as value or in % (in conjunction
with <_AMODE> HUNDRED THOUSANDS)
Data type Meaning
REAL Retraction plane (abs)
REAL Reference point (abs)
REAL Safety clearance (to be added to reference point, enter without sign)
REAL Final drilling depth (abs), see <_AMODE>
REAL Final drilling depth (inc), see <_AMODE>
REAL 1st drilling depth (abs), see <_AMODE>
REAL 1st drilling depth (inc), see <_AMODE>
REAL Degression value / percentage for each additional infeed,
see <_AMODE>
REAL Dwell time at drilling depth, see <_AMODE>
REAL Dwell time at start point (for chip removal only), see <_AMODE>
REAL Percentage for the feedrate for the first infeed, see <_AMODE>
INT Machining type
UNITS:
INT Tool axis
REAL Minimum infeed (only for degression percentage)
REAL Retraction distance after each machining step (for chip breaking only)
REAL Dwell time at final drilling depth, see <_AMODE>
Chip breaking/removal
0 = Chip breaking
1 = Swarf removal
0 = 3rd geometry axis
1 = 1st geometry axis
2 = 2nd geometry axis
> 2 3rd geometry axis
> 0 Variable retraction distance
0 = Default value 1 mm
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming