CTABSEG:
CTABFSEG:
CTABMSEG:
CTABPOLID:
CTABPOL:
CTABFPOL:
CTABMPOL:
<n>:
<memory
location>:
<segment type>:
3.16.3
Axial master value coupling (LEADON, LEADOF)
Note
This function is not available for SINUMERIK 828D!
With the axial master value coupling, a leading and a following axis are moved in synchronism.
It is possible to assign the position of the following axis via a curve table or the resulting
polynomial uniquely to a position of the leading axis – simulated if necessary.
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Determine the number of curve segments of the specified <segment
type> used in the specified <memory location>
Determine the number of curve segments of the specified <segment
type> remaining possible in the specified <memory location>
Determine the maximum possible number of curve segments of the speci‐
fied <segment type> in the specified <memory location>
Determine the number of curve polynomials used by curve table number <n>
Determine the number of curve polynomials used in the specified <memory
location>
Determine the number of curve polynomials remaining possible in the speci‐
fied <memory location>
Determine the maximum possible number of curve polynomials in the speci‐
fied <memory location>
Number (ID) of curve table
Specification of memory location (optional)
Static NC memory
"SRAM"
Dynamic NC memory
"DRAM"
Note:
If a value is not programmed for this parameter, the default memory location
set with MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
Specification of segment type (optional)
Linear segments
"L"
Polynomial segments
"P"
Note:
If no value is programmed for this parameter, the sum of the linear and poly‐
nomial segments is output.
Work preparation
3.16 Axis couplings
911