Siemens SINUMERIK 840D sl Programming Manual page 1274

Tables
4.4 Predefined procedures
Protection areas
Identifier Parameter
1.
CPROT INT:
Number of the
protection
area
NPROT INT:
Number of the
protection
area
Preprocessing / single block
Identifier Parameter
STOPRE
SBLOF
SBLON
1274
2. 3.
INT: Option REAL: Offset
of the protec‐
0: Protection
tion area in
area OFF
the first geom‐
1: Preactivate
etry axis
protection
area
2: Protection
area ON
3: Preactivate
protection
area with con‐
ditional stop,
only with pro‐
tection areas
active
INT: Option REAL: Offset
of the protec‐
0: Protection
tion area in
area OFF
the first geom‐
1: Preactivate
etry axis
protection
area
2: Protection
area ON
3: Preactivate
protection
area with con‐
ditional stop,
only with pro‐
tection areas
active
4. 5.
REAL: Offset REAL: Offset
of the protec‐ of the protec‐
tion area in tion area in
the second the third ge‐
geometry axis ometry axis
REAL: Offset REAL: Offset
of the protec‐ of the protec‐
tion area in tion area in
the second the third ge‐
geometry axis ometry axis
Explanation
Preprocessing stop until all prepared blocks in the main
run are executed
Suppress single-block processing
Cancel suppression of the single-block processing
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Explanation
Channel-specific pro‐
tection area ON/OFF
Machine-specific pro‐
tection area ON/OFF
NC programming