Siemens SINUMERIK 840D sl Programming Manual page 795

<W1>:
<W1>:
Note
Parameters that have not been programmed have the default value "0".
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Thousands po‐ Specifies which positions of the solutions may be modified when the
sition: hundreds position has the value "0", i.e. for the "Tool alignment"
function.
0xxx The calculated axis positions should be as close as possible
1xxx The calculated axis positions for modulo axes should be as
2xxx The calculated axis positions should be reduced to the range
First angle
The meaning results from the hundreds position of the <Cntrl> paramter.
Data type: REAL
Second angle
The meaning results from the hundreds position of the <Cntrl> paramter.
Data type: REAL
If the angles <W1> and <W2> are selected arbitrarily, the
cutting edge of the tool is generally not in the machining
plane. The angle γ through which the cutting edge is rotated
out of the machining plane, must not be greater than the limit
value which is defined by the setting data SD42999 $SC_OR‐
ISOLH_INCLINE_TOL.
to the current machine axis positions.
close as possible to the middle of the modulo range, for other
axes as close as possible to 0. For non-modulo axes, this
means that the axis positions are reduced to the range
-180° ... +180°.
-180° ... +180° irrespective of the axis type.
Work preparation
3.13 Tool offsets
795