Curve Tables: Determine Table Properties (Ctabid, Ctabislock, Ctabmemtyp, Ctabperiod) - Siemens SINUMERIK 840D sl Programming Manual

Work preparation
3.16 Axis couplings
<m>:
<memory
location>:
If CTABLOCK/CTABUNLOCK is programmed without specification of the curve table to be
locked/unlocked, then all curve tables or all curve tables in the specified memory will be locked/
unlocked:
CTABLOCK():
CTABLOCK(,,"SRAM"):
CTABLOCK(,,"DRAM"):
CTABUNLOCK():
CTABUNLOCK(,,"SRAM"):
CTABUNLOCK(,,"DRAM"):
3.16.2.5 Curve tables: Determine table properties (CTABID, CTABISLOCK, CTABMEMTYP,
CTABPERIOD)
These commands can be used to poll important properties of a curve table (table number, lock
state, memory location, periodicity).
Syntax
CTABID(<p>)
CTABID(<p>,<memory location>)
CTABISLOCK(<n>)
CTABMEMTYP(<n>)
TABPERIOD(<n>)
904
When a curve table range CTABLOCK(<n>,<m>)/CTABUNLOCK(<n>,<m>)
is locked/unlocked, <m> is used to specify the number of the last curve table
in the range.
<m> has to be greater than <n>.
Specification of memory location (optional)
In the case of locking/unlocking without a memory location being specified, the
specified curve tables are locked/unlocked in the static and the dynamic NC
memory.
In the case of locking/unlocking with a memory location being specified, of the
specified curve tables, only those located in the specified memory location are
locked/unlocked. The rest are not locked/unlocked.
Lock/unlock in the static NC memory
"SRAM"
Lock/unlock in the dynamic NC memory
"DRAM"
Locks all curve tables in the static and the dynamic NC memory
Locks all curve tables in the static NC memory
Locks all curve tables in the dynamic NC memory
Unlocks all curve tables in the static and dynamic NC memory
Unlocks all curve tables in the static NC memory
Unlocks all curve tables in the dynamic NC memory
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming