Cycle82 - Drilling, Counterboring - Siemens SINUMERIK 840D sl Programming Manual

No. Parameter Parameter
mask internal
4 Z1/∅
<DP>
5 Z1
<DPR>
6 DT
<DTB>
7
<_GMODE>
8
<_DMODE>
9
<_AMODE>
3.25.1.22

CYCLE82 - drilling, counterboring

Syntax
CYCLE82(<RTP>, <RFP>, <SDIS>, <DP>, <DPR>, <DTB>, <_GMODE>,
<_DMODE>, <_AMODE>, <_VARI>, <S_ZA>, <S_FA>, <S_ZD>, <S_FD>)
Parameter
No. Parameter Parameter
mask internal
1 RP
<RTP>
2 Z0
<RFP>
3 SC
<SDIS>
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Data type Meaning
REAL Drilling depth (abs) / centering diameter (abs), see <_GMODE>
REAL Drilling depth (inc)
REAL Dwell time at final drilling depth, see <_AMODE>
INT Geometrical mode (evaluation of programmed geometrical data)
UNITS:
TENS:
INT Display mode
UNITS:
INT Alternative mode
UNITS:
TENS:
Data type Meaning
REAL Retraction plane (abs)
REAL Reference point (abs)
REAL Safety clearance (to be added to reference point, enter without sign)
Work preparation
3.25 Programming cycles externally
Reserved
Centering with respect to depth/diameter
0 = Compatibility, depth
1 = Diameter
Machining plane G17/G18/G19
0 = Compatibility, the plane effective
before the cycle call remains ac‐
tive
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR pro‐
gramming
1 = Incremental
2 = Absolute
Dwell time at final drilling depth DT in
seconds/revolutions
0 = Compatibility, from DTB sign (> 0
seconds or < 0 revolutions)
1 = In seconds
2 = In revolutions
1065