Siemens SINUMERIK 840D sl Programming Manual page 956

Work preparation
3.18 Oscillation
Meaning
OSP1[<oscillating axis>]=
OSP2[<oscillating axis>]=
OST1[<oscillating axis>]=
OST2[<oscillating axis>]=
FA[<oscillating axis>]=
OSCTRL[<oscillating axis>]=
OSNSC[<oscillating axis>]=
OSE[<oscillating axis>]=
WAITP(<oscillating axis>)
Axis assignment, infeed
OSCILL[<oscillating axis>]=(<infeed axis 1>,<infeed axis 2>,<infeed
axis 3>)
POSP[<infeed axis>]=(<end position>,<partial length>,<mode>)
OSCILL:
POSP:
End position:
Partial
length:
Mode:
Motion-synchronous actions
WHEN... ... DO
WHENEVER ... DO
956
Position of reversal point 1
Position of reversal point 2
Stopping time at reversal point 1 in seconds
Stopping time at reversal point 2 in seconds
Feed for oscillating axis
Set or reset options
Number of sparking-out strokes
End position
Enable axis for oscillation
Assign infeed axis or axes for oscillating axis
Define complete and partial infeeds (see Section "File and Program Management")
End position for the infeed axis after all partial infeeds have been traversed.
Length of the partial infeed at reversal point/reversal area
Division of the complete infeed into partial infeeds
= Two residual steps of equal size (default);
= All partial infeeds of equal size
when..., do...
whenever..., do...
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming