Replacing The Shear Bolt At The Rotary Hub - Krone ActiveMow R 200 Operating Instructions Manual

Rear mounted mower
Table of Contents

Advertisement

14
Maintenance - Cutterbar
14.2

Replacing the shear bolt at the rotary hub

14.2
Replacing the shear bolt at the rotary hub
NOTICE
Wrong installation position
The machine may be damaged if the installation position of the bearing housings is not
observed.
„ Clockwise rotating (RH) cutting discs / mower drums always have right-handed pinion
shaft and nut (no groove mark on pinion shaft and nut).
„ Anti-clockwise rotating (LH) cutting discs / mower drums always have left-handed pinion
shaft and nut (with groove mark on pinion shaft and nut).
KM000-049_1
ü The machine is in the working position,
ü The machine is shut down and safeguarded,
„ Dismount the cutting disc or the mower drum at the rotary hub with the defective shear bolt.
„ Remove the retaining ring (7).
„ Unscrew the screws (8).
„ Use the special key (10) included with delivery to unscrew the nut (2).
„ Dismount the hub (1).
„ Remove the damaged shear pins (3).
„ Check the nut and hub for damage.
68
refer to
page 47.
refer to
page 24.
Original Operating Instructions 150000521_04_en
ActiveMow R 200

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ActiveMow R 200 and is the answer not in the manual?

Table of Contents