Deviating Tightening Torques; Venting The Friction Clutch - Krone ActiveMow R 200 Operating Instructions Manual

*) Always replace copper rings
11.3

Deviating tightening torques

Screws/nuts
Nut for shear protection (rotary hub)
Bearing housing for cutting disc
Bearing housing for mower drum
11.4

Venting the friction clutch

NOTICE
Interventions in the friction clutch will lead to a loss of guarantee!
Interventions in the friction clutch change the slip torque. Therefore the machine may be
damaged considerably.
„ Never intervene in the overload protection.
„ Only use KRONE original spare parts.
The friction clutch protects the tractor and the machine from damage. The friction clutch must be
vented at the beginning of the storage period. The friction clutch is designed with a permanently
adjusted turning torque M
Venting friction clutch (Walterscheid)
KM000-072
ü The machine is in the working position,
ü The machine is shut down and safeguarded,
„ Remove the universal shaft.
„ Tighten the nuts (1) evenly.
ð The friction discs are relieved.
„ Turn the friction clutch (2).
„ Turn the nuts (1) back as far as the thread run-out.
ActiveMow R 200
Original Operating Instructions 150000521_04_en
Maintenance - General Information
Tightening torque
300 Nm
55 Nm
55 Nm
. The torque is applied to the housing of the friction clutch (2).
R
refer to
refer to
Deviating tightening torques
page 47.
page 24.
11
11.3
61