Mode; Rate - Powerware Plus 80 Operation

Mode

Rate

1
Powemare Plus
I
.
TABLE C. Options Available for Each Communication Port
Port I Port2
X X
X X
X X
X
X X
X X
X
X X
X X
modes:
Terminal mode
Calibration
Alarm Config.
Computer
Remote Monitor Sends all system event information to a remote
Port 1 and Port 2 cannot be placed in the same mode simultaneously; they must
always be operating in different modes. The modes are described in the following
chapter.
The baud rate of the equipment connected lo this
speed of data transterrad
Monitor mode, the baud rate must be sat
the highest baud rate available
recommended for any mode omer than Remote Monitor.
You can select a baud
Options
Terminal mode
Calibration mode
Alarm Configuration
mode
Remote Monitor mode
Saud rate of 300. 1200,2400.4800.9600.
Data size/stoD bits Of 811 Or 812
Data size/stop biis of 711 or 712
Disabled handshaking
System events are logged immediately as they
occur.
Used only by service personnel.
(Not yet implemented)
Allows you to use Binary Computer Mode (BCM).
monitor panel (RMP). Available for Port 1 only.
the UPS and the connected equipment. For Remote
rate of 300,1200,2400,4800.%00.
or 19.2@I
one of these
or 19,200.
7