Powerware Plus 80 Operation page 115

Installing Line-Up-and-Match 'lope 2 battery Cabinets
Before beginning the following procedures, be sure you have prepared the UPS for
installation of lineup-and-match battery cabinets (see page 17). Refer to Figure 22
on page 36 for the location of items mentioned in these procedures.
To wire line-up-and-match 7'jpe 2 battery cabinets together:
1.
I
2. In the adjoining cabinet to the left. remove the screws securing the right cable
I
3. Mate the left cable connector and left wire plug in battery cabinet #I to the right
I
4. Repeat steps 1 through 3 for each battery cabinet to be joined.
I
To wire a iine-up-and-match TLpe 2 battery cabinet to the UPS:
1.
I
2. Mate the left cable connector and the left wire plug with the UPS battery cable
I
I
I
4. Mount the right side panel (removed from the UPS) to the right side of the end
I
I
I
6.
I
7. Attach a ground bus between joined cabinet frames using the procedure On
I
All battery cabinets will arrive at your site with each battery connection string
electrically disconnected. Remove the screws that secure the left cable
connector, and remove the tiewrap securing the left wire plug.
connector.
cable connector and fixed right wire plug in the adjoining cabinet to the left.
Figure 22 on page 36 shows the cutout for routing of battery cable and wire.
A UPS battery cable connector is supplied inside the UPS cabinet. lt is
connected to terminals E4 and E5 and tlewrapped in place. Remove the screws
that secure the left cable connector,.and remove the tiewrap securing the left
wire plug.
connector and remote interface plug (1 supplied) inside.the UPS cabinet. See
Figure 22 on page 36 and Drawing 164200253-7 on page A-l 6 to locate the
cutouts for routing of battery cable and wire.
battery strings in the battery cabinet by mating all disconnected battery drawer
connectors to the closest string connectors.
battery cabinet
b.
Hang the tight side panel on the hanger bracket and align it with the
of the
front and rear
C. Secure the rigM side panel at the bottom.
steps from the UPS preparation procedure on page 17.
Replace all battery cabinet center deadfronts.
page 26.
together."
battery cabinet.
Plus 60 UPS Installation Manual