Powerware Plus 80 Operation page 71

Remote Monitor Mode
Remote Monitor mode allows you to connect a port to a Remote Monitor Panel (RMP) or a
Relay Interface module (RIM). This mode provides the communications settings required
for the RMP or RIM to communicate
must always be set to 300 baud. You can install up to two remote accessories
I
facility, up to 500 feet from the UPS.
The RMP contains a local horn and these backlit status indicators:
I
I
I
I
The relay interface module (RIM) uses relay contact closures to indicate the operating
status and alarm condition of me UPS system. The RIM can provide these signals:
I
UPS AVAILABLE (connector
I
UPS OFF LINE (connector plnr 3 and 13)
I
For
more
I
I
I
I
I
1 2
SYSTEM NORMAL
NOREDUNDANCY
ON GENERATOR
ON BYPASS
UPS ALARM
ON BAlTERY
BYPASS UNAVAILABLE
SHUTDOWN IMMINENT
information about the RMP and RIM indicators, see
For information about installing an RMP or an RIM. see
pins
1 and 12)
Power-ware Plus 80 UPS Communication