Powerware Plus 80 Operation page 107

Installing 'lope 1 Stand-Alone Battery Cabinets
To prepare l)fpe 1 battery cabinets for stand-alone installation:
I
I
I
I
I
I
To wire stand-alone 7Lpe 1 battery cabinets together:
I
I
I
I
I
I
Before beginning the following procedures, be sure you have prepared the UPS for
installation of the Type 1 battery cabinets. Refer to Figure 20 on page 31 for the
location of items mentioned in these procedures.
1.
Remove the right side panel.
2. Remove the hanger bracket
screws for later use.
4. Unlock the left side door of the battery cabinet using the key provided. Open
the door (press the top of the door latch, twist the latch lever clockwise Fro', and
pull out).
WARNING:
LETHAL VOLTAGE WILL BE PRESENT WHEN PERFORMING THE
REMAINING STEPS IN THIS SECTION AND SUBSEQUENT SECTIONS.
6.
each cabinet.
electrically disconnected. Remove the screws that secure the left cable
connector, and remove the tiewrap securing the left wire plug. Sea Figure 20 for
connector and plug locations.
2. In the adjoining battery cabinet to the left, remove the screws securing the right
cable connector guard. Remove and discard the guard and hardware.
4. Repeat steps 1 through 3 for each battery cabinet to be joined.
- i