Displaying Service Profile Information - 3Com WX1200 3CRWX120695A Configuration Manual

Displaying Service
Profile Information
WX# display service-profile sp1
ssid-name:
Beacon:
DHCP restrict:
Short retry limit:
Auth fallthru:
Enforce SODA checks:
Custom success web-page:
Custom logout web-page:
Static COS:
CAC mode:
User idle timeout:
Keep initial vlan:
Web Portal ACL:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
vlan-name = orange
session-timeout = 300
service-type = 2
11a beacon rate:
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate:
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate:
The WX does not need to be the one that booted the MAP, but it must
have the MAP in its configuration. Also, the WX that booted the MAP
must be in the same Mobility Domain as the WX where you use the
command.
To display service profile information, use the following command:
display service-profile {name | ?}
Entering display service-profile ? displays a list of the service profiles
configured on the switch.
To display information for service profile sp1, type the following
command:
corp2
yes
none
yes
none
180
<none>
<none>
NO
6.0
2.0
2.0
ssid-type:
Proxy ARP:
no No broadcast:
5 Long retry limit:
Sygate On-Demand (SODA):
SODA remediation ACL:
Custom failure web-page:
Custom agent-directory:
no COS:
CAC sessions:
Idle client probing:
no Web Portal Session Timeout:
WEP Key 2 value:
WEP Key 4 value:
1 WEP Multicast Index:
multicast rate:
multicast rate:
multicast rate:
Displaying MAP Information 259
crypto
no
no
5
no
0
14
yes
5
<none>
<none>
1
AUTO
AUTO
AUTO