Ip Interfaces And Services Configuration Scenario - 3Com WX1200 3CRWX120695A Configuration Manual

IP Interfaces and
Services
Configuration
Scenario
WX1200# set interface mgmt ip 10.10.10.10/24
success: change accepted.
WX1200# set interface roaming ip 10.20.10.10/24
success: change accepted.
WX1200# display interface
VLAN Name
---- --------------- --------------- --------------- ------- -----
2 default
3 roaming
4094 web-aaa
WX1200# set system ip-address 10.20.10.10
success: change accepted.
WX1200# display system
===============================================================================
Product Name:
System Name:
System Countrycode: US
System Location:
System Contact:
System IP:
System idle timeout:3600
System MAC:
===============================================================================
Boot Time:
Uptime:
===============================================================================
Fan status:
Temperature: temp1 ok
PSU Status:
Memory:
Total Power Over Ethernet : 105.6
===============================================================================
This scenario configures IP interfaces, assigns one of the interfaces to be
the system IP address, and configures a default route, DNS parameters,
and time and date parameters.
1 Configure IP interfaces on the mgmt and roaming VLANs, and verify the
configuration changes. Type the following commands:
Address
10.10.10.10
10.20.10.10
10.10.10.1
The 10.10.10.1 interface in VLAN web-aaa is placed into the route table
automatically by MSS, to support WebAAA.
2 Configure the IP interface on the roaming VLAN to be the system IP
address and verify the configuration change. Type the following
commands:
WX1200
WX1200
10.02.10.10
00:0B:0E:00:04:0C
2000-03-18 22:59:19
0 days 01:12:02
fan1 OK fan2 OK fan3 OK
temp2 ok
Lower Power Supply DC ok AC ok
156.08/496.04 (31%)

IP Interfaces and Services Configuration Scenario

Mask
255.255.255.0
255.255.255.0
255.255.255.0
temp3 ok
Upper Power Supply missing
Enabled State
YES Up
YES Up
YES Up
135