3Com WX1200 3CRWX120695A Configuration Manual page 231

WX# display ap status 8
AP: 7, AP model: AP3750, manufacturer: 3Com, name: AP08
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
Uptime: 1 hours, 8 minutes, 17 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled]
operational channel: 1 operational power: 1
base mac: 00:0b:0e:0a:60:00
bssid1: 00:0b:0e:0a:60:00, ssid: public
Table 18 lists the MAP security options and whether a MAP can establish
a management session with a WX based on the option settings.
Table 18 MAP Security Requirements
MAP Security MAP Has
Setting Fingerprint?
MAP Security Yes
Required
No
MAP Security Yes
Optional
No
* MSS generates a log message listing the MAP serial number and fingerprint so
you can verify the MAP's identity. (See "Fingerprint Log Message" on page 233.)
Verifying a MAP Fingerprint on a WX Switch
To verify a MAP fingerprint, find the fingerprint and use the set ap
fingerprint command to enter the fingerprint in MSS.
Finding the Fingerprint A MAP fingerprint is listed on a label on the
back of the MAP. (See "Encryption Key Fingerprint" on page 230.)
If the MAP is already installed and operating, use the display ap status
command to display the fingerprint. The following example shows
information for Distributed MAP 8, including its fingerprint:
id=0x29f1886d447f111a ram=33554432
s/n=0424000779 hw_rev=A3
Configuring MAPs
MAP Can Establish
Fingerprint Management
Verified in MSS? Session with Switch?
Yes Yes
No No
Not Applicable No
Yes Yes
No Yes
Not Applicable Yes
231
*
*