3Com WX1200 3CRWX120695A Configuration Manual page 221

Table 16 Configurable Profile Parameters for Distributed MAPs
Parameter
MAP Parameters
bias
blink
(Not shown in display ap config
output)
force-image download
group (load balancing group)
mode
persistent
upgrade-firmware
(boot-download-enable)
Radio Parameters
radio num auto-tune max-power default
radio num mode
radio num radio-profile
radiotype
MAPs that receive their configurations from the Auto-AP profile also
receive the radio settings from the radio profile used by the Auto-AP
profile. Likewise, the SSIDs and encryption settings come from the service
profiles mapped to the radio profile. To use a radio profile other than
default, you must specify the radio profile you want to use. (See
"Specifying the Radio Profile Used by the Auto-AP Profile" on page 222.)
Changing MAP Parameter Values The commands for configuring
MAP and radio parameters for the Auto-AP profile are the same as the
commands for configuring an individual Distributed MAP. Instead of
specifying a Distributed MAP number with the command, specify auto.
For more information about the syntax, see the "MAP Commands"
chapter of the Wireless LAN Switch and Controller Command
Configuring MAPs
Default Value
high
disable
disable (NO)
none
disabled
none
enable (YES)
enabled
default
11g
(or 11b for country codes where
802.11g is not allowed)
221
Reference.