3Com WX1200 3CRWX120695A Configuration Manual page 630

630 C A: T
HAPTER ROUBLESHOOTING A
WX S
WITCH
Mark messages are disabled by default. When they are enabled, MSS
generates a message at the notice level once every 300 seconds by
default.
To enable mark messages, use the following command:
WX4400# set log mark enable
success: change accepted.
Saving Trace Messages in a File
To save the accumulated trace data for enabled traces to a file in the WX
switch's nonvolatile storage, use the following command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the
following command:
WX1200# save trace traces/trace1
Displaying the Log Configuration
To display your current log configuration, type the following command:
WX1200# display log config
Logging console:
Logging console severity:
Logging sessions:
Logging sessions severity:
Logging buffer:
Logging buffer severity:
Logging buffer size:
Logging trace:
Logging trace severity:
Logging buffer size:
Log marking:
Log marking severity:
Log marking interval:
Logging server:
EMERGENCY
severity
Current session:
Current session severity:
enabled
INFO
enabled
INFO
enabled
ERROR
400 messages
enabled
DEBUG
1048576 bytes
disabled
NOTICE
300 seconds
172.21.12.19 port 514 severity
CRITICAL
disabled
INFO