3Com WX1200 3CRWX120695A Configuration Manual page 236

236 C 10: C
HAPTER ONFIGURING
MAP A P
CCESS OINTS
Table 19 Transmit Rates
Parameter Default Value
mandatory 11a— 6.0,12.0,24.0
11b—1.0,2.0
11g—1.0,2.0,5.5,11.0
disabled None. All rates applicable
to the radio type are
supported by default.
beacon-rate 11a—6.0
11b—2.0
11g—2.0
Description
Set of data transmission rates that
clients are required to support in order
to associate with an SSID on a MAP
radio. A client must support at least one
of the mandatory rates.
These rates are advertised in the basic
rate set of 802.11 beacons, probe
responses, and reassociation response
frames sent by MAP radios.
Data frames and management frames
sent by MAP radios use one of the
specified mandatory rates.
The valid rates depend on the radio type:
11a—6.0, 9.0, 12.0, 18.0, 24.0,
36.0, 48.0, 54.0
11b—1.0, 2.0, 5.5, 11.0
11g—1.0, 2.0, 5.5, 6.0, 9.0, 11.0,
12.0, 18.0, 24.0, 36.0, 48.0, 54.0
Use a comma to separate multiple rates;
for example: 6.0,9.0,12.0
Data transmission rates that MAP radios
will not use to transmit data. This
setting applies only to data sent by the
MAP radios. The radios will still accept
frames from clients at disabled data
rates.
The valid rates depend on the radio type
and are the same as the valid rates for
mandatory.
If you disable a rate, you cannot use the
rate as a mandatory rate or the beacon
or multicast rate. All rates that are
applicable to the radio type and that are
not disabled are supported by the radio.
Data rate of beacon frames sent by
MAP radios. This rate is also used for
probe-response frames.
The valid rates depend on the radio type
and are the same as the valid rates for
mandatory. However, you cannot set
the beacon rate to a disabled rate.