3Com WX1200 3CRWX120695A Configuration Manual page 102

102 C 5: C
HAPTER ONFIGURING AND
WX1200# set port type wired-auth 5,6
success: change accepted
WX1200# display port status
Port Name
===============================================================================
1 mgmt
2 finance
3 accounting
4 shipping
5 lobby
6 lobby
7 conf_room1
8 conf_room1
WX1200# set vlan default port 1
success: change accepted.
WX1200# display vlan config
VLAN Name
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default
4094 web-aaa
M P
ANAGING ORTS AND
4 Configure ports 5 and 6 as wired authentication ports and verify the
configuration change. Type the following commands:
Admin Oper
up up
up up
up up
up up
up up
up up
up up
up up
5 Configure ports 7 and 8 as a load-sharing port group to provide a
redundant link to the backbone, and verify the configuration change.
Type the following commands:
WX1200# set port-group name backbonelink port 7,8 mode on
success: change accepted.
WX1200# display port-group
Port group: backbonelink is up
Ports:
6 Add port 1 to the default VLAN (VLAN 1) and verify the configuration
change. Type the following commands:
Admin VLAN
Status State Affin Port
Up Up
Up Up
7 Save the configuration. Type the following command:
WX1200# save config
success: configuration saved.
VLAN
S
Config Actual
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
auto 100/full
7, 8
Tunl
5
1
0
2
Type Media
network 10/100BaseTx
ap 10/100BaseTx
ap 10/100BaseTx
ap 10/100BaseTx
wired auth 10/100BaseTx
wired auth 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
Port
Tag State
none Up
4094 Up