3Com WX1200 3CRWX120695A Configuration Manual page 203

Table 10 Defaults for Service Profile Parameters (continued)
Parameter
auth-fallthru
auth-psk
beacon
cac-mode
cac-session
cipher-ccmp
cipher-tkip
cipher-wep104
cipher-wep40
cos
dhcp-restrict
idle-client-probing
long-retry-count
Radio Behavior When Parameter
Default Value Set to Default Value
web-auth Uses WebAAA for users who do not
match an 802.1X or MAC
authentication rule for the SSID
requested by the user.
disable Does not support using a preshared key
(PSK) to authenticate WPA clients.
enable Sends beacons to advertise the SSID
managed by the service profile.
none Does not limit the number of active
user sessions based on Call Admission
Control (CAC).
14 If session-based CAC is enabled
(cac-mode is set to session), limits the
number of active user sessions on a
radio to 14.
disable Does not use Counter with Cipher
Block Chaining Message
Authentication Code Protocol (CCMP)
to encrypt traffic sent to WPA clients.
enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP)
to encrypt traffic sent to WPA clients.
disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt
traffic sent to WPA clients.
disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
0 If static CoS is enabled (static-cos is set
to enable), assigns CoS 0 to all data
traffic to or from clients.
disable Does not restrict a client's traffic to only
DHCP traffic while the client is being
authenticated and authorized.
enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
5 Sends a long unicast frame up to five
times without acknowledgment.
MAP Overview 203