Enabling The Snmp Service; Displaying Snmp Information; Displaying Snmp Version And Status Information; Displaying The Configured Snmp Community Strings - 3Com WX1200 3CRWX120695A Configuration Manual

151 C 7: C
HAPTER ONFIGURING
Enabling the SNMP
Service
Displaying SNMP
Information
Displaying SNMP
Version and Status
Information
Displaying the
Configured SNMP
Community Strings
Displaying USM
Settings
SNMP
This command configures target 1 at IP address 10.10.40.9. The target's
SNMP engine ID is based on its address. The MSS SNMP engine will send
notifications based on the default profile, and will require the target to
acknowledge receiving them.
The following command configures a notification target for
unacknowledged notifications:
WX1200# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
To enable the MSS SNMP service, use the following command:
set ip snmp server {enable | disable}
The following command enables the SNMP service:
WX1200# set ip snmp server enable
success: change accepted.
You can display the following SNMP information:
Version and status information
Configured community strings
User-based security model (USM) settings
Notification targets
SNMP statistics counters
To display SNMP version and status information, use the following
command:
display snmp status
To display the configured SNMP community strings, use the following
command:
display snmp community
To display USM settings, use the following command:
display snmp usm