Displaying Acl Information For A Map - 3Com WX1200 3CRWX120695A Configuration Manual

Displaying ACL
Information for a
MAP
4 green
5 yellow
(For information about the fields in the output, see the
Switch and Controller Command
When a MAP is configured to perform local switching, you can display
the number of packets filtered by security ACLs ("hits") on the MAP.
Each time a packet is filtered by a security ACL, the MAP's ACL hit
counter increments. To display ACL hits for a MAP, use the following
command:
display ap acl hits ap-number
For MSS to count hits for a security ACL, you must specify hits in the set
security acl commands that define ACE rules for the ACL.
The following command displays the security ACL hits on MAP 7,
WX# display ap acl hits 7
ACL hit-counters for AP 7
Index Counter
----- -------------------- --------
1
2
3
To display a summary of the security ACLs that are mapped on a MAP,
use the following command:
display ap acl map ap-number
This command lists only the ACLs that have been mapped on the
specified MAP. To list all committed ACLs, use the display security acl
info command. To list ACLs that have not yet been committed, use the
display security acl editbuffer command.
Displaying MAP Information
local
radio_1
tunnel wx_tun
radio_1
Reference.)
ACL-name
0 acl_2
0 acl_175
916 acl_123
265
1 4
23
5
24
Wireless LAN