3Com WX1200 3CRWX120695A Configuration Manual page 175

The following is the Network Domain configuration for this scenario:
1 Make the WX switch with IP address 10.10.10.1 a seed of a Network
Domain called globaldom and establish a peer relationship with the WX
switch with IP address 20.20.20.1. Type the following commands:
WX1200# set network-domain mode seed domain-name globaldom
success: change accepted.
WX1200# set network-domain peer 20.20.20.1
success: change accepted.
2 Make the WX switch with IP address 20.20.20.1 a seed of a Network
Domain called globaldom and establish a peer relationship with the WX
switch with IP address 10.10.10.1. Type the following commands:
WX1200# set network-domain mode seed domain-name globaldom
success: change accepted.
WX1200# set network-domain peer 10.10.10.1
success: change accepted.
3 Make the three WX switches in Mobility Domain A members of the
Network Domain, specifying WX switch 10.10.10.1 as the their Network
Domain seed. Type the following command on all three WX switches:
WX1200# set mobility-domain mode member seed-ip 10.10.10.1
success: change accepted.
4 Make the WX switches in Mobility Domains B and C members the
Network Domain, specifying WX switch 20.20.20.1 as the their Network
Domain seed. Type the following command on all of the WX switches in
both Mobility Domains:
WX1200# set mobility-domain mode member seed-ip 20.20.20.1
success: change accepted.
5 Display the Network Domain status. Type the following command on the
WX switch with IP address 10.10.10.1:
WX1200# display network-domain
Network Domain name: globaldom
Peer
---------------
20.20.20.1
Member
---------------
---------------
10.10.10.1
10.10.10.2
10.10.10.3
Network Domain Scenario
State
-------------
UP
State
-------------
UP
UP
UP
Mode
------
SEED
MEMBER
MEMBER
175