Specifying The Rsn Cipher Suites - 3Com WX1200 3CRWX120695A Configuration Manual

Specifying the RSN
Cipher Suites
To use RSN, at least one cipher suite must be enabled. You can enable
one or more of the following cipher suites:
CCMP
TKIP
40-bit WEP
104-bit WEP
By default, TKIP is enabled and the other cipher suites are disabled.
To enable or disable cipher suites, use the following commands:
set service-profile name cipher-ccmp {enable | disable}
set service-profile name cipher-tkip {enable | disable}
set service-profile name cipher-wep104 {enable | disable}
set service-profile name cipher-wep40 {enable | disable}
To enable the CCMP cipher suite in service profile rsn, type the following
command:
WX1200# set service-profile rsn cipher-ccmp enable
success: change accepted.
After you type this command, the service profile supports both TKIP and
CCMP.
Microsoft Windows XP does not support WEP with RSN. To configure a
service profile to provide WEP for XP clients, leave RSN disabled and see
"Configuring WEP" on page 299.
Configuring RSN (802.11i) 297