3Com WX1200 3CRWX120695A Configuration Manual page 212

212 C 10: C
HAPTER ONFIGURING
MAP A P
CCESS OINTS
Table 13 Radio-Specific Parameters (continued)
Parameter Default Value
antennatype For most MAP models, the
default is internal.
For MP-620, the default for the
802.11b/g radio is
ANT-1360-OUT. The default for
the 802.11a radio is
ANT-5360-OUT.
The default for the 802.11b/g
radio on model MP-262 is
ANT1060.
auto-tune Highest setting allowed for the
max-power country of operation or highest
setting supported on the
hardware, whichever is lower
channel 802.11b/g — 6
802.11a — Lowest valid
channel number for the
country of operation
mode disable
radio-profile None. You must add the radios
to a radio profile.
tx-power Highest setting allowed for the
country of operation or highest
setting supported on the
hardware, whichever is lower.
Although these parameters have default values, 3Com recommends that
you change the values for each radio for optimal performance. For
example, leaving the channel number on each radio set to its default
value can result in high interference among the radios.
(To configure these parameters, see "Configuring Radio-Specific
Parameters" on page 246.)
Description
3Com external antenna model
This parameter is configurable
only on MAPs that support
external antennas.
Maximum percentage of client
retransmissions a radio can
experience before RF
Auto-Tuning considers changing
the channel on the radio.
(To configure RF Auto-Tuning,
see "Configuring
RF Auto-Tuning" on page 311.)
Number of the channel in which
a radio transmits and receives
traffic
Operational state of the radio.
802.11 settings
Transmit power of a radio, in
decibels referred to 1 milliwatt
(dBm)