Using Log Commands - 3Com WX1200 3CRWX120695A Configuration Manual

Using Log Commands

Table 54 Event Severity Levels (continued)
Severity
notice
info
debug
To enable, disable, or modify system logging to the WX switch's log
buffer, console, current Telnet session, or trace buffer, use the following
command:
set log {buffer | console | current | sessions | trace}
[severity severity-level] [enable | disable]
To configure system logging to a syslog server, use the following
command:
set log server ip-addr [port port-number] severity
severity-level [local-facility facility-level]
To enable periodic mark messages for use in troubleshooting, use the
following command:
set log mark [enable | disable] [severity level]
[interval interval]
To view log entries in the system or trace buffer, use the following
command:
display log buffer | trace
To clear log messages from the system or trace buffer, use the following
command:
clear log buffer | trace
To stop sending messages to a syslog server, use the following command:
clear log server ip-addr
Configuring and Managing the System Log
Description
Events that potentially can cause system problems have
occurred. These are logged for diagnostic purposes. No
action is required.
Informational messages only. No problem exists.
Output from debugging.
The debug level produces a lot of messages, many of which
can appear to be somewhat cryptic. Debug messages are
used primarily by 3Com for troubleshooting and are not
intended for administrator use.
625