Changing Power Tuning Settings - 3Com WX1200 3CRWX120695A Configuration Manual

Changing RF Auto-Tuning Settings 317
Changing the Channel Tuning Interval
The default channel tuning interval is 3600 seconds. You can change the
interval to a value from 0 to 65535 seconds. If you set the interval to 0,
RF Auto-Tuning does not reevaluate the channel at regular intervals.
However, RF Auto-Tuning can still change the channel in response to RF
anomalies. 3Com recommends that you use an interval of at least 300
seconds (5 minutes).
To change the channel tuning interval, use the following command:
set radio-profile name auto-tune channel-interval seconds
To set the channel tuning interval for radios in radio profile rp2 to 2700
seconds (45 minutes), type the following command:
WX1200# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
Changing the Channel Holddown Interval
The default channel holddown interval is 900 seconds. You can change
the interval to a value from 0 to 65535 seconds. To change the channel
holddown interval, use the following command:
set radio-profile name auto-tune channel-holddown holddown
To change the channel holddown for radios in radio profile rp2 to 600
seconds, type the following command:
WX1200# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
Changing Power Enabling Power Tuning
Tuning Settings
RF Auto-Tuning for power is disabled by default. To enable or disable the
feature for all radios in a radio profile, use the following command:
set radio-profile name auto-tune
power-config {enable | disable}
To enable power tuning for radios in the rp2 radio profile, type the
following command:
WX1200# set radio-profile rp2 auto-tune power-config enable
success: change accepted.