Data; Communicate With Your Module - Rockwell Automation POINTBlock Series User Manual

Default Data Map for the 1734-IE2C Analog Input Module
Message Size: 6 Bytes
15
Produces (scanner Rx) Input Channel 0 High Byte
Input Channel 1 High Byte
Status Byte for Channel 1
OR
Consumes (scanner Tx) No consumed data
Where: CF = Channel Fault status; 0 = no error, 1 = fault
LA = Low Alarm; 0 = no error, 1 = fault
LLA = Low/Low Alarm: 0 = no error, 1 = fault
UR = Underrange; 0 = no error, 1 = fault
Default Data Map for the 1734-IE2V Analog Input Module
Message Size: 6 Bytes

Data

The1734-IE2C module operates in unipolar mode only; the 1734-IE2V
module operates in unipolar or bipolar modes. Data returned from the
module is scaled by the user to any 16-bit signed integer (–32,768...+32,767).
Six bytes of data are read from the 1734-IE2C and 1734-IE2V modules. No
data is written to the input modules.
• Channel 0 Data (2 bytes)
• Channel 1 Data (2 bytes)
• Channel 0 Status (1 byte)
• Channel 1 Status (1 byte)

Communicate with Your Module

I/O messages are sent to (consumed) and received from (produced) the
POINT I/O modules. These messages are mapped into the processor's
(1)
memory. These POINT I/O input modules produces six bytes of input
data (scanner Rx) and fault status data. It does not consume output data
(scanner Tx).
14 13 12 11
UR HHA LLA HA
15 14 13 12 11
(1)
These are mapped through scan lists in DeviceNet networks and Direct, Listen Only, or Rack-optimized
connections in ControlNet and EtherNet/IP networks.
10 09 08 07 06
Input Channel 0 Low Byte
Input Channel 1 Low Byte
Status Byte for Channel 0
LA CM CF OR UR
CM = Calibration Mode; 0 = normal, 1 = calibration mode
HA = High Alarm; 0 = no error, 1 = fault
HHA = High/High Alarm; 0 = no error, 1 = fault
OR = Overrange; 0 = no error, 1 = fault
10 09 08 07
POINT I/O Module Data
05 04 03 02
HHA LLA HA LA
06 05 04 03 02
Publication 1734-UM001D-EN-P - April 2008
105
01 00
CM CF
01 00