Rockwell Automation POINTBlock Series User Manual page 209

2. From the Fault/Program Action dialog, complete items, referring to the
table.
For This Value
Fault Mode
Fault Value
Program Mode
Program Value
3. From the bottom of the dialog, perform one of the following:
• Click another tab at the top of the dialog.
or
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply
button when you make changes to any of the dialogs
Configure POINT I/O Modules in RSLogix 5000 Software
Select Comments
• Hold Last State
Default is Go to Low Clamp.
• Go to Low Clamp
• Go to High Clamp
• Use Program
Value
-32768...32767 Default is 0.
• Hold Last State
Default is Go to Low Clamp.
• Go to Low Clamp
• Go to High Clamp
• Use Program
Value
-32768...32767 Default is 0.
Publication 1734-UM001D-EN-P - April 2008
207