Rockwell Automation POINTBlock Series User Manual page 193

Feature Description
Point Displays the channel numbers.
• Select a value to determine the behavior of each output when the controller transitions to the Program mode.
Program
Mode
• Make a selection from the available values for each channel:
- Off (default)
- On
- Hold
• In Hard Run only, you disable editing this feature.
• Select a value to determine the behavior of each output when communication with the controller fails.
Fault
Mode
• Select from the available values for each channel:
- Off (default)
- On
- Hold
• In Hard Run only, you disable editing this feature.
• with overload and open load diagnostic status.
2. From the Fault/Program Action dialog, complete entries, referring to
the table for a summary of how to make these entries.
3. From the Fault/Program Action dialog, perform one of the following:
• Click another tab at the top of the dialog.
or
• Click OK, which closes the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply
button when you make changes to any of the dialogs.
Configure POINT I/O Modules in RSLogix 5000 Software
Publication 1734-UM001D-EN-P - April 2008
191