Table of Contents
Advertisement
186
Configure POINT I/O Modules in RSLogix 5000 Software
Publication 1734-UM001D-EN-P - April 2008
About Fault/Program Action and Configuration Dialogs
You see Fault/Program Action and Configuration dialogs based on the
module and connection types. Refer to the following table.
For Module Type
With Connection Type
Input
Data
Listen Only
Listen Only - Rack Optimization
Rack Optimization
Output
Data
Listen Only
Listen Only - Rack Optimization
Rack Optimization
(1)
You see tabs for General, Connection, and Module Info for all module and connection types.
Understanding Data and Connection Formats
For digital modules, the choices for data format and connection type are as
follows:
• Data Format - Integer
• Connection Type - Data, Listen only, Listen only - rack optimization,
Rack optimization
When you change entries for data format and connection type, note:
• You do not delete the existing module.
• You do not create a new module.
• You bring forward configuration data for the new settings.
• Any configuration data you do not bring forward sets to the default
value.
After you apply new settings for data format and connection, note the
following:
• This is the base configuration for the next change in connection and
data format settings.
• You lose all configuration data from previous data formats.
(1)
You See These Tabs
Fault/Program Action
x
x
Configuration
x
x
x
x
Hide quick links:
Advertisement
Table of Contents
