Rockwell Automation POINTBlock Series User Manual page 200

198 Configure POINT I/O Modules in RSLogix 5000 Software
For This Value
High Engineering
Low Engineering
Digital Filter (ms)
Current Range
Voltage Range
Real Time Sample (ms)
Notch Filter
Publication 1734-UM001D-EN-P - April 2008
2. From the Configuration dialog, complete entries, referring to the table.
Select
-32768...32767
-32768...32767
0...10000
4...0 mA
0...20 mA
-10...10V
0...10V
0...10000
50 Hz
60 Hz
250 Hz
500 Hz
Real Time Notch Filter Setting
Sample
50 Hz
Min 120 ms
3. From the bottom of the Configuration dialog, perform one of the
following:
• Click another tab at the top of the dialog.
or
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply
button when you make changes to any of the dialogs.
Comments
• Default for 1734-IE2C analog input module is 16383.
• Default for 1734-IE2V analog input module is 10000.
• Default for 1734-IE2C analog input module is 3277.
• Default for 1734-IE2V analog input module is 0.
Default is 0.
Default is 4...20 mA.
Default is 0...10V
Default is 100.
Refer to the Real Time Sample Values table for the relationship
between Notch Filter and Real Time Sample.
Default is 60 Hz.
Refer to the Real Time Sample Values table for the relationship
between Notch Filter and Real Time Sample.
Real Time Sample Values
60 Hz
100 ms
250 Hz 500 Hz
24 ms 12 ms