Confirm The Ip Address And Test The Audio - CyberData InformaCast Enabled 011407 Operation Manual

2.2.15 Confirm the IP Address and Test the Audio

2.2.15.1 RTFM Switch
When the InformaCast Enabled Loudspeaker Amplifier (PoE) is operational and linked to the
network, use the Reset Test Function Management (RTFM) switch
hole on the device) to announce and confirm the device's IP Address and test the audio to verify that
it is working.
Announcing the IP
To announce a device's current IP address:
Address
•
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Use a bent paperclip or a similar object to press and hold the RTFM switch until you hear the
2. Release the RTFM switch. The device will be restored to the factory default settings.
Operations Guide
Use a bent paperclip or a similar object to press and hold the RTFM switch for a couple of
seconds and then release it.
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the device to the factory default settings. See the
the Factory Default
GENERAL ALERT
device announce the words, "restoring defaults" and "rebooting".
Installing the InformaCast Enabled Loudspeaker Amplifier (PoE)
InformaCast Enabled Loudspeaker Amplifier (PoE) Setup
Figure 2-19. RTFM Switch
Settings" section.
931277I
(Figure 2-19) (located behind the
RTFM switch 
(located behind the hole 
on the device)
"Restoring
CyberData Corporation
28