Confirm The Ip Address And Test The Audio - CyberData 011324 Series Operation Manual

2.2.10 Confirm the IP Address and Test the Audio

2.2.10.1 RTFM Switch
When the SIP Paging Amplifier is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
confirm the device's IP Address and test the audio to verify that it is working.
RTFM switch (located behind the hole on the device)
RTFM
Announcing the IP To announce a device's current IP address:
Address
•
Restoring the
To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Use a bent paperclip or a similar object to press and hold the RTFM switch for several seconds.
2. Release the RTFM switch. The device will be restored to the factory default settings, and will
Operations Guide
(Figure
Link / Act.
Use a bent paperclip or a similar object to briefly press the RTFM switch and release it.
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the device to the factory default settings. See the
the Factory Default
GENERAL ALERT
announce "restoring defaults" and "rebooting."
2-19) (located behind the hole on the device) to announce and
Figure 2-19. RTFM Switch
Status
Power
Settings" section.
931971A
Installing the SIP Paging Amplifier
SIP Paging Amplifier Setup
Paging
The IP Endpoint Company
CyberData Corporation
23
"Restoring