Factory Default Settings - CyberData InformaCast Enabled 011407 Operation Manual

2.3 Configure the InformaCast Enabled Loudspeaker
Amplifier (PoE) Parameters
To configure the InformaCast Enabled Loudspeaker Amplifier (PoE) online, use a standard web
browser.
Configure each InformaCast Enabled Loudspeaker Amplifier (PoE) and verify its operation before
you mount it. When you are ready to mount an InformaCast Enabled Loudspeaker Amplifier (PoE),
refer to

2.3.1 Factory Default Settings

All InformaCast Enabled Loudspeaker Amplifier (PoE)s are initially configured with the following
default IP settings:
When configuring more than one InformaCast Enabled Loudspeaker Amplifier (PoE), attach the
InformaCast Enabled Loudspeaker Amplifier (PoE)s to the network and configure one at a time to
avoid IP address conflicts.
Operations Guide
Appendix A, "Mounting the Amplifier"
Table 2-7. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
a. Default if there is not a DHCP server present.
Installing the InformaCast Enabled Loudspeaker Amplifier (PoE)
InformaCast Enabled Loudspeaker Amplifier (PoE) Setup
for instructions.
Factory Default Setting
DHCP
10.10.10.10
admin
admin
a
255.0.0.0
a
10.0.0.1
931277I CyberData Corporation
32