Confirm The Ip Address And Test The Audio - CyberData 011403 Operation Manual

2.2.10 Confirm the IP Address and Test the Audio

2.2.10.1 RTFM Switch
When the InformaCast Enabled Paging Amplifier is operational and linked to the network, use the
Reset Test Function Management (RTFM) switch
device) to announce and confirm the device's IP Address and test the audio to verify that it is
working.
RTFM switch (located behind the hole on the device)
RTFM
Announcing the IP
To announce a device's current IP address:
Address
•
Restoring the
To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Use a bent paperclip or a similar object to press and hold the RTFM switch for several seconds.
2. Release the RTFM switch. The device will be restored to the factory default settings, and will
Operations Guide
Link / Act.
Use a bent paperclip or a similar object to briefly press the RTFM switch and release it.
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the device to the factory default settings. See the
the Factory Default
GENERAL ALERT
announce "restoring defaults" and "rebooting."
Installing the InformaCast Enabled Paging Amplifier
(Figure
Figure 2-19. RTFM Switch
Status
Power
Settings" section.
931976A
InformaCast Enabled Paging Amplifier Setup
2-19) (located behind the hole on the
Paging
The IP Endpoint Company
CyberData Corporation
23
"Restoring