Confirm The Ip Address And Test The Audio - CyberData 011085 Operation Manual

2.2.6 Confirm the IP Address and Test the Audio

2.2.6.1 RTFM Switch
When the Paging Amplifier is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
Paging Amplifier's IP Address, and test that the audio is working.
Announcing the IP To announce a Paging Amplifier's current IP address:
Address
1. Press and hold the RTFM switch until you hear the IP address announcement.
2. Release the RTFM switch.
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the IP address announcement. Continue holding
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.
Operations Guide
(Figure
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds after the IP address announcement will restore the V2 Paging Amplifier
to the factory default settings. See the
GENERAL ALERT
section.
the RTFM switch for an additional five seconds until you hear the Paging Amplifier announce the
words, "restoring defaults" and "rebooting".
2-14) on the Paging Amplifier face to announce and confirm the
Figure 2-14. RTFM Switch
"Restoring the Factory Default
930363H
Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
RTFM switch
Settings"
CyberData Corporation
15