Confirm The Ip Address And Test The Audio - CyberData 011116 Operation Manual

2.2.7 Confirm the IP Address and Test the Audio

2.2.7.1 RTFM Switch
When the Loudspeaker Amplifier is operational and linked to the network, use the Reset Test
Function Management (RTFM) switch
and confirm the Loudspeaker Amplifier's IP Address, and test that the audio is working.
Announcing the IP To announce a Loudspeaker Amplifier's current IP address:
Address
1. Press and hold the RTFM switch until you hear the IP address announcement.
2. Release the RTFM switch.
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the IP address announcement. Continue holding
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.
Operations Guide
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds after the IP address announcement will restore the V2 Paging Amplifier
to the factory default settings. See the
GENERAL ALERT
section.
the RTFM switch for an additional five seconds until you hear the Paging Amplifier announce
the words, "restoring defaults" and "rebooting".
(Figure 2-14) on the Loudspeaker Amplifier face to announce
Figure 2-14. RTFM Switch
"Restoring the Factory Default
930377F
Installing the VoIP V2 Loudspeaker Amplifier
Loudspeaker Amplifier Setup
CyberData Corporation
15
RTFM switch
Settings"