Confirm The Ip Address And Test The Audio - CyberData 011406 Operation Manual

2.2.11 Confirm the IP Address and Test the Audio

2.2.11.1 RTFM Switch
When the Singlewire InformaCast Loudspeaker Amplifier is operational and linked to the network,
use the Reset Test Function Management (RTFM) switch
InformaCast Loudspeaker Amplifier face to announce and confirm the Singlewire InformaCast
Loudspeaker Amplifier's IP Address and test the audio to verify that it is working.
Announcing the IP
To announce a Singlewire InformaCast Loudspeaker Amplifier's current IP address:
Address
•
Restoring the
To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the device announce the words, "restoring
2. Release the RTFM switch. The device will be restored to the factory default settings.
Operations Guide
Press and hold the RTFM switch for a couple of seconds and then release it.
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds will restore the device to the factory default settings. See the
the Factory Default
GENERAL ALERT
defaults" and "rebooting".
Singlewire InformaCast Loudspeaker Amplifier (AC-Powered) Setup
Figure 2-17. RTFM Switch
Settings" section.
931281B
Confirm the IP Address and Test the Audio
(Figure 2-17) on the Singlewire
CyberData Corporation
21
RTFM switch
"Restoring