Confirm The Ip Address And Test The Audio - CyberData 11085 Operation Manual

2.2.6 Confirm the IP Address and Test the Audio

2.2.6.1 RTFM Switch
When the Paging Amplifier is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
the Paging Amplifier's IP Address, and test that the audio is working.
Announcing the IP
To announce a Paging Amplifier's current IP address:
Address
1. Press and hold the RTFM switch until you hear the IP address announcement.
2. Release the RTFM switch.
Restoring the To restore the factory default settings, complete the following steps:
Factory Default
Settings
1. Press and hold the RTFM switch until you hear the IP address announcement. Continue holding
the RTFM switch for an additional five seconds until you hear the Paging Amplifier announce
the words, "restoring defaults" and "rebooting".
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.
Operations Guide
Caution
Equipment Caution: Pressing and holding the RTFM switch for more than five
seconds after the IP address announcement will restore the V2 Paging Amplifier
to the factory default settings. See the
GENERAL ALERT
section.
(Figure 2-13) on the Paging Amplifier face to announce and confirm
Figure 2-13. RTFM Switch
930363B
Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
"Restoring the Factory Default
CyberData Corporation
14
RTFM switch
Settings"