Figure 27: Measured Values - Overview - WAGO 750-494 Series Manual

90 Commissioning
The Overview view displays the measured values of all three phases
continuously. These are:
• A sum view (Phase L1-L3) with active, reactive and apparent power, power
factor PF, active, reactive and apparent energy.
• 4-quadrant display per phase
• Rotating field of the 3-phase supply network
• Current, voltage Lx-N, active, reactive and apparent power, cos phi, Power
factor PF and frequency per phase. Overcurrent, under and overvoltage are
identified as a red square, if not present as a green one.
Change of the Measuring Units!
Specify the prefixes of the measuring units by selecting Home > Settings >
Application. See section "Configuration with WAGO-I/O-CHECK" >
"Application" Tab.
The units can only be changed in the lists with the same physical variables. For
lists with different variables, base units are always used!
Figure 27: Measured Values ‒ Overview
WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
Manual
Version 1.2.0