Figure 28: Measured Values - Phases - WAGO 750-494 Series Manual

WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
Selecting Phase L1 (resp. L2 or L3) Measurements, the measured values of the
respective phase are displayed in detailed including min., max., average and peak
values. Note: Peak values are only displayed if this phase was selected for peak
value measurement. See section "Configuration with WAGO-I/O-CHECK" > "I/O
module" Tab. Overcurrent, under and overvoltage are identified as a red square, if
not present as a green one.
• Current
• Voltage Lx-N
• Phase-to-phase voltage
• Active power
• Reactive power
• Apparent power
• 4-quadrant display
• cos phi, power factor PF, power factor LF
• Active energy
• Reactive energy
• Apparent energy
Figure 28: Measured Values ‒ Phases
Manual
Version 1.2.0
Commissioning 91