WAGO-I/O-SYSTEM 750
750-494 3-Phase Power Measurement Module
8.1.1
"Application" Tab
Make application settings in the "Application" tab. These settings are not stored in
the I/O module, but on the connected PC.
You specify again the decimal multiples for displaying the measuring units for the
various measured variables or keep them:
-3
10
=milli or 10
In addition, you specify the storage path for the measured value records. See
"Measurement Recording" in the following section "Displaying the Measured
Values via WAGO-I/O-CHECK".
Figure 22: „Application" Tab
Manual
Version 1.2.0
0
3
=1 or 10
=kilo.
Commissioning
83