Figure 29: Measured Values - Currents And Voltages; 3-Phase Power Measurement Module - WAGO 750-494 Series Manual

92 Commissioning
Currents/Voltages displays all currents, voltages, phase angles and frequencies,
including min., max., average and peak values.
Note: Peak values are only displayed for the phase which was selected for peak
value measurement. See section "Configuration with WAGO-I/O-CHECK" > "I/O
module" Tab.
Overcurrent, under and overvoltage are identified as a red square, if not present as
a green one.
• Current
• Voltage Lx-N
• Phase-to-phase voltage
• Phase angle
• Frequency
Figure 29: Measured Values ‒ Currents and Voltages
WAGO-I/O-SYSTEM 750

750-494 3-Phase Power Measurement Module

Manual
Version 1.2.0